Text Box: Wormbot’s

Text Box: Assembly

Text Box:   Wormbot is fairly simple to assemble.   Directions:   · Insert the ends of both linear actuator arms into the aluminum sleeve with their bolt holes lined up with the holes in the aluminum sleeve and aligned vertically · This is the tricky part. Lift both linear actuators and the sleeve and lower the sleeve’s holes with the aluminum bars that stick out of the centre weight. · Attach a control device to each actuator at the appropriately labeled connector · Plug the cords into the extension cord, unravel the cords and try to keep them from being a major factor in the experiment. It is not particularly feasible to power the actuators by battery as it lasts about 10 minutes with industrial 9V batteries.

Text Box: gbosdet@hotmail.com  

Text Box: Questions?